How To Change Your Disarm Code

1. Switch on the ignition without starting the engine.

2. Enter the current disarm sequence - 2 flash confirmation.

3. Press and hold the accelerator pedal to the floor (alternative for some vehicles).

4. Enter the current disarm sequence again - indication will start to flash once every 3 seconds, this means the Ghost is in learn mode.

5. Release the accelerator pedal.

6. Enter the new disarm sequence.

7. Wait for 3 flashes.

8. Enter the new disarm sequence again.

9. Wait for 2 flashes to confirm the process was successful, 4 flashes means there was an error. If so repeat from step 1.

​

How To Enter & Exit Valet/Service Mode

Entry

1. Disarm the system using your disarm sequence.

2. Drive to, and park up at the dealership, airport, valeter’s etc and while the engine is still running, press your service button 5 times.

3. The indication lamp will flash back at you 5 times to confirm service / valet mode has been entered.

4. Turn off the vehicle.

​Exit 

1. Turn on the ignition without starting the engine.

2. Enter the current disarm sequence - 2 flash confirmation.

3. The next time the ignition is switched off the Ghost will rearm as normal.

​

​

Input Emergency Disarm Code

1. Take Note Of The 4 Digit Code Found In The Top Right Hand Side Of Your Ghost Card. (eg.3241)

2. Switch on the ignition.

3. Depress and hold the brake pedal.

4. Press the accelerator pedal to the floor a number of times corresponding to the first digit of the code. (eg.3)

5. Release the brake pedal to confirm the first digit.

6. Depress and hold the brake pedal.

7. Press the accelerator pedal to the floor a number of times corresponding to the second digit of the code. (eg.2)

8. Release the brake pedal to confirm the second digit.

9. Depress and hold the brake pedal.

10. Press the accelerator pedal to the floor a number of times corresponding to the third digit of the code. (eg.4)

11. Release the brake pedal to confirm the third digit.

12. Depress and hold the brake pedal.

13. Press the accelerator pedal to the floor a number of times corresponding to the forth digit of the code. (eg.1)

14. Release the brake pedal to confirm the third digit.

15. The indicators will begin to flash.

16. Now follow the How To Change Your Disarm Code from step.

​