Jaguar Landrover (JLR) Notes!

If your vehicle does not detect the key when immobilised. your push sequence will be required before step 1 to disarm the system and get the ignition on.

 

 

How To Change Your Disarm Code

1. Switch on the Ignition.

2. Disarm the system using your push sequence.(JLR vehicles, skip this step)

3. Press the accelerator pedal 10x .

4. Recieve 2 flashes.

5. Enter the new code .

6. Turn the ignition off within 5 seconds

7. Recieve 1 flash

8. Your new code is now set

​

​

​

How To Enter & Exit Valet/Service Mode

​​​Entry

1. Switch on the ignition.

2. Disarm the system using the unique code and hold the last button.

3. Once you recieve 5 flashes release the button.

4. Service/Valet mode is now activate

 

​Exit

1. Switch on the ignition.

2. Disarm the system using the unique code and hold the last button.

3. Once you recieve 1 flash release the button.

4. Immobiliser mode is now activate

 

 

Emergency Disarm Code (not applicable to all vehicles)

 

1. Take note of the 6 digit override code unique to your device.(eg.523432)

2. Switch on the ignition.

3. Press the brake pedal & hold,press the accelerator pedal x amount of times for your first digit(eg.5).

4. Release brake pedal and recieve a flash to confirm this digit has been accepted.

5. Press the brake pedal & hold,press the accelerator pedal x amount of times for your second digit(eg.2).

6. Release brake pedal and recieve a flash to confirm this digit has been accepted.

7. Press the brake pedal & hold,press the accelerator pedal x amount of times for your third digit(eg.3).

8. Release brake pedal and recieve a flash to confirm this digit has been accepted.

9. Press the brake pedal & hold,press the accelerator pedal x amount of times for your forth digit(eg.4).

10. Release brake pedal and recieve a flash to confirm this digit has been accepted.

11. Press the brake pedal & hold,press the accelerator pedal x amount of times for your fifth digit(eg.3).

12. Release brake pedal and recieve a flash to confirm this digit has been accepted.

13. Press the brake pedal & hold,press the accelerator pedal x amount of times for your sixth digit(eg.2).

14. Release brake pedal and recieve a 4 flashes to confirm the code has been accepted and the system is disarmed.

15. Follow the How To Change Your Disarm Code above to set a new push sequence